Overview - FLANGING Tool
WARNING: This page is about a different variant/trim than selected.
- Flanging Tool Upper Section
- Remove to replace the Flaring Jaws.
- Handle Fastener
- Must be removed to reach the upper section bolt
- Bolt
- For the flanging tool upper section
- Threaded Pins for Flaring Jaws
- Center and hold the Flaring Jaws
- 2 mm inner hex socket
- Flaring Jaws
- Variance
- Assembly instructions. Refer to Fig 2
Assembly Instructions for Flaring Jaws:
- : VAS6056/6 (dark) for black brake lines
- : VAS6056/7 (light) for green brake lines
NOTE:
The arrow on the rounded side of the Flaring Jaws must point toward the edge of the housing.
The straight side of the Flaring Jaws must be installed toward spindle, otherwise flared head will not be formed correctly.