Brake Lamp Switch -F-, REMOVING AND INSTALLING, LHD WITH 5-CYLINDER GASOLINE ENGINE: Removing

-- Open clamp -2- and disconnect intake hose.

Fig 1: Disconnecting Connector And Intake Hose

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If equipped, disconnect the connector -1- and remove.

-- Remove the bolts -3- and the intake hose.

-- Pull the engine with a jerk out of the fasteners first at the front -arrow 1-, then at the right rear -arrow 2- and finally at the left rear -arrow 3-.

Fig 2: Identifying Removal Of Engine Cover With Jerk Out Of Mount First

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Carefully swivel engine cover out of rear area.

-- Release and disconnect the connector -1-.

Fig 3: Brake Lamp Switch

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the screw -2- from the brake master cylinder.

-- Remove the Brake Lamp Switch -- -3- from under the brake master cylinder and up from the clip -4-.