Brake Fluid Reservoir, Removing And Installing, RHD: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

Coat the plugs with brake fluid before pressing the brake fluid reservoir into the brake master cylinder.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

Vehicles with Manual Transmission:

-- Bleed the clutch. Refer to the appropriate service information .

Continuation for All Vehicles:

Fig 1: Identifying Brake Fluid Level Marks On Reservoir

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

To prevent the brake fluid from overflowing from the reservoir, the level must not be over the MAX mark -1-.