Refrigerant Circuit Seals

WARNING: This page is about a different variant/trim than selected.

Replace the seals after removing.
Coat the seals with refrigerant oil before installing.
Make sure the seals are positioned correctly on the pipe or in the groove.
Ensure cleanliness when working. Even the smallest contaminant, a hair for example, can cause a leak.
Only install seals that are resistant to refrigerant R1234yf and the corresponding refrigerant oil. Refer to Parts Information.

The dimensions -a and b- are dependent on the component location of the seal. Refer to Parts Information.

Fig 1: Identifying Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Refer to SEALS for additional information and notes.