ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, RHD WITH ABS MARK 60 EC ABS/EDL/ASR/ESP: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

CAUTION:

Do not confuse the brake lines when connecting them to the ABS Hydraulic Unit -N55-. Pay attention to the marked installation position.

NOTE:

Remove the plugs on the new ABS Hydraulic Unit -N55- only when installing the corresponding brake line.

Brake fluid may leak out if the plugs are removed from the ABS Hydraulic Unit -N55- beforehand and the unit may not be sufficiently filled or adequately bled.

WARNING:

When installing, make sure the damper rubber is not pushed out of the bracket. Make sure the ABS Hydraulic Unit -N55- is secure after installing it otherwise malfunctions can occur.

-- Connect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the Brake Pedal Actuator: VAG1869/2 .

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

Perform a basic setting on the Steering Angle Sensor -G85-, the Transverse Acceleration Sensor -G200- and the Brake Pressure Sensor 1 - G201- after installing the ABS Control Module -J104- and the ABS Hydraulic Unit -N55-. Refer to Vehicle diagnostic tester.

If a new ABS Control Module -J104- was installed, it must be coded. Refer to Vehicle diagnostic tester.