LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 49 (Antilock Brake System (Convertible)) >> 45 Antilock Brake System >> Control Module And Hydraulic Unit >> ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING >> ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, LHD VEHICLES WITH A DIESEL ENGINE >> Installing

ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, LHD VEHICLES WITH A DIESEL ENGINE: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Remove the plugs on the new ABS Hydraulic Unit -N55- only when installing the corresponding brake line.

Brake fluid may leak out if the plugs from the ABS Hydraulic Unit -N55- are removed beforehand and the unit may not be sufficiently filled or adequately bled.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Code the ABS Control Module -J104- using the Vehicle Diagnostic Tester.

While doing so, a basic setting for the Steering Angle Sensor -G85-, Transverse Acceleration Sensor -G200-, Longitudinal Acceleration Sensor -G251- and Brake Pressure Sensor 1 -G201- must be performed.

scientia non olet · About LEMON Manuals