Gliding Piece, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Slider And Seat Rail

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the slider into the seat rail -1- by slightly tipping it toward the tunnel.

-- Engage the slider in the back catch -arrow-.

-- Tighten the rear bolt on the seat on the tunnel side (40 Nm).

-- Tilt the backrest back while sliding the seat all the way back (entry assistance).

-- Release the seat forward/back adjuster and slide the front seat into the desired position.

NOTE:

It is not necessary to adjust the slider.