Entry Assistance Release Cable A, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Make sure the backrest is in its normal position. Move the backrest all the way forward using the hand wheel.

-- Attach the >>entry assistance<< cable A -1- first to the seat forward/back adjustment -2-.

Fig 1: Disengage Entry Assistance Release Cable A -1- At Seat Forward/Back Adjuster -2- And Remove It

GWWA72-10632

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Engage the >>entry assistance<< cable A support bracket -1- on the seat forward/back adjustment -2-.

Fig 2: Identifying Entry Assistance Release Cables

GWWN72-10424

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the >>entry assistance<< release cable A -1- to the backrest hinge.

Fig 3: Disengage Entry Assistance Release Cable A -1- At Backrest Hinge

GWWA72-10728

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the >>entry assistance<< release cable A guides -2- on the seat frame.

-- Adjust the >>entry assistance<< release cable A. Refer to ENTRY ASSISTANCE RELEASE CABLE A, ADJUSTING .

-- Lock the >>entry assistance<< release cable A -1- with the clip -2-.

Fig 4: Locking Entry Assistance Release Cable A -1- With Clip

GWWA72-10729

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Further installation is the reverse order of removal.

When installing, make sure that the release cables -1 and 2- are routed as shown. Never cross the release cables!

Fig 5: Identifying Release Cables

GWWN72-10425

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.