Passenger Occupant Detection System Deactivation After A Collision, Market-Specific
WARNING: This page is about a different variant/trim than selected.
- Each time front passenger airbag and/or belt tensioner on the front passenger side is deployed, Passenger Occupant Detection System Control Module -J706- basic setting must be performed. Perform the basic setting using Vehicle Diagnostic Tester.
- If the seat rail and/or seat pan is replaced due to deformations resulting from a crash, the Passenger Occupant Detection System Pressure Sensor -G452- must be replaced. Perform a basic setting on the Passenger Occupant Detection System Control Module -J706-. Perform the basic setting using Vehicle Diagnostic Tester.