Assembly Instructions
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Wiring Harness Repair Set - Hot Air Blower:VAS1978/14A
- Adhesive Strip Remover:VAS6349
- It is not possible to remove the sill panel trim without damaging it.
- Warm the sill panel trim before removing using the :VAS1978/14A .
- If installing the sill panel trim for the first time on a new vehicle or a newly painted surface, follow the procedure. Refer to Paint service information; →Paint Repairs; →Paint Finish; →Decorative Molding and Films.
- If removing the sill panel trim, only use the Adhesive Remover:D 002 000 10 to remove the adhesive residue.
- If necessary, remove any adhesive residue left by the tape using :VAS6349 .
- Make sure the adhesive surfaces are free of dust and grease.
- Install the sill panel trim immediately after cleaning.
- Only remove the protective film right before assembly.
- The temperature is approximately 21 °C (69.8 °F).