Exhaust System, Installing Without Tension: Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

The -arrow- points in the direction of travel.

-- Loosen the threaded connections for the front clamping sleeve -arrow-.

Fig 1: Locating Clamping Sleeve Screws

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the exhaust system far enough forward until the pre-load on the retaining loops at the exhaust pipe -a- = 9 mm.

Fig 2: Identifying Tail Pipe Aligning

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tail Pipes, Aligning

-- Align the rear muffler so that the distance -a and b- between the bumper opening and the tail pipes is the same.

Fig 3: Aligning Exhaust System

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the rear muffler to align the tail pipes.

-- Install the clamping sleeve. Refer to CLAMPING SLEEVE INSTALLATION POSITION .