Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING: Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Loosen the hose clamps -3 and 5-.

Fig 1: Identifying Senors And Clamps

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector from the Charge Air Pressure Sensor -G31- -arrow-.

-- Remove the bolts -1 and 4- and then remove the air duct pipe downward.

-- Disconnect the connector -1- from the Throttle Valve Control Module -GX3-.

Fig 2: Identifying Throttle Valve Control Module Electrical Connector And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- for the Throttle Valve Control Module -GX3- from below and remove the Throttle Valve Control Module -GX3-.