Intake Manifold, Removing And Installing: Installing

-- If the connections on the high pressure pump were loosened, replace the connections.

-- Position the intake manifold on the cylinder head and tighten the connector bracket -A-.

Fig 1: Locating Bracket Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the nuts -A- hand-tight.

Fig 2: Locating Intake Manifold Nuts And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -arrows- evenly, working from the inside to the outside. Use the : T10347  .

-- Further installation is the reverse order of removal.