Oxygen Sensor 1 After Catalytic Converter -GX7-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the nuts -arrows- from the right underbody panel and pull the underbody panel slightly downward.

Fig 1: Identifying Right Vehicle Floor Cover Nuts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the connector -arrow- from the bracket -2- and disconnect it.

Fig 2: Identifying Three Way Catalytic Converter And Oxygen Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Oxygen Sensor 1 after Catalytic Converter -GX7- -1- using a tool from the : 3337 .