Overview - Charge Air System: Notes
WARNING: This page is about a different variant/trim than selected.
- Air Duct Hose
- Installing. Refer to Fig 2.
- Rubber Bushing
- For the charge air cooler
- Left
- Bolt
- 8 Nm
- Charge Air Cooler
- Removing and Installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- Rubber Bushing
- For the charge air cooler
- Right
- Bolt
- 8 Nm
- Rubber Bushing
- For lower charge air cooler in body
- Right
- Rubber Bushing
- For lower charge air cooler in body
- Left
- Seal
- Replace if damaged
- Bolt
- 7 Nm
- Air Duct Hose
- Installing. Refer to Fig 2.
- Spring Clip
- Check for proper seating
- Bolt
- 7 Nm
- Air Duct Pipe
- Bolt
- 7 Nm
- Air Duct Pipe
- Bolt
- 7 Nm
- O-Ring
- Replace after removing.
- Charge Air Pressure Sensor -G31-
- Removing and Installing. Refer to Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING .
- Air Duct Hose
- Installing. Refer to Fig 2.
Air Ducts with Screw-Type Clamps, Installing
NOTE:
The hose connections as well as air duct pipes and hoses must be free of oil and grease before installing.
Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
To safely secure the air duct hoses to their connections, spray the screws on the previously used screw-type clamps with rust remover.