Flexible Air Distribution Shaft, Checking
WARNING: This page is about a different variant/trim than selected.
Check the Adjuster Flexible Shaft on the Air Distribution Doors
- Set the Fresh Air Blower -V2- on the highest blower speed.
- Select "Defrost" on the display control head.
- For example, if air flows out of the defroster vents in the "Defrost" position and no air flows out of footwell vents, then the flexible shaft was installed correctly.
- Otherwise disconnect the flexible shaft from the display control head again. Place the display control head front section on the rear section and turn the air distribution control a 1 /2 (180°) turn. Insert the flexible shaft again and repeat the test.