Vacuum Pump, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Locating Bolts And Vacuum Pump

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the sealing surfaces.

-- Position the vacuum pump driver so it engages in the groove on the camshaft when vacuum pump is installed.

-- Position the new seal on the vacuum pump and insert the two bolts. Position the vacuum pump with the seal on the cylinder head.

-- While doing so pay attention that it lays flush on the flange.

Further assembly is performed in the reverse order of the removal.

-- Install the high pressure pump with >>roller tappet<<. Refer to HIGH PRESSURE PUMP, REMOVING AND INSTALLING .