Oil Spray Jets, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Oil Spray Jets - Installation Position

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

There is a risk of damaging the oil spray jets through distortions.

- Never bend the oil spray jets.

Install in reverse order of removal and note the following:

The side surface of the oil spray jet -1- must be parallel to the neighboring crankshaft bearing -2-.
Dimension -a- = Dimension -a-

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .