Sub-Assembly Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

Replace the O-rings and seals.

-- Coat the new O-rings -4- with coolant. Refer to Parts Information for the coolant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the connection -2- into the coolant pump housing -3-.

-- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts. Refer to Figure.

-- Install the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING .

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to Filling .