LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Hood, Lids (Convertible)) >> 55 Hood, Lids >> Rear Lid >> Rear Lid, Removing And Installing >> Rear Lid, Removing And Installing, Sedan >> Removing

Rear Lid, Removing And Installing, Sedan: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Rear Lid Components
GWWM55-10091Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the rear lid lower trim panel. Refer to REAR LID LOWER TRIM PANEL .

-- Disconnect the connectors from any electrical components.

-- Loosen the boot -4- and guide the wires -1- through the opening and out of the rear lid.

-- Loosen, but do not remove, the bolts -5- on the left and right hinges -3-.

A second technician is required for the rest of the removal procedure.

-- Remove the left and right gas-filled struts -2- from the rear lid. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .

-- First remove the bolts -5- and the rear lid.