Right Seal, Replacing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in the reverse order of removal while noting the following:

-- Coat the outer circumference and the sealing lips on the new seal with ATF.

-- Install the new seal until it stops using the :T10177 . Do not tilt the seal.

Fig 2: Identifying Installation Of Seal Using Thrust Piece T10177

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the right driveshaft to the transmission. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Check the ATF level and add if necessary. Refer to ATF .

-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .