Valve Body, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50 Nm:VAG1331
- Digital Torque Wrench:VAG1756A
WARNING:
Do not run the engine or tow the vehicle when the transmission fluid pan is removed or when there is no ATF in the transmission.
NOTE:
Always replace a contaminated or faulty valve body.
The valve body and the wiring harnesses can also be removed and installed with the transmission installed.
Install the O-rings with ATF. Other types of lubrication leads to faults in the transmission control module hydraulics.
Only use lint-free cloths
The ATF must be filled and the ATF level checked after installing the ATF pan. Refer to ATF LEVEL, CHECKING .