Auxiliary Heater Heating Element -Z35-, ACTIVATION SWITCH-ON CRITERIA
WARNING: This page is about a different variant/trim than selected.
NOTE:
For vehicles without an A/C system, the activation is switched off as soon as one of the switch-on requirements is no longer met in engine control module or one of the switch-off criteria is detected.
- When one of the switch-on requirements is no longer met.
- The calculated outside air temperature is higher than 11 °C (51.8 °F).
- The Generator -C- load is greater than 95 %.
- There is no longer a ground signal at the engine control module from the Heater Control Module -J65-.