Recirculation Door Motor -V113-, REMOVING AND INSTALLING: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Screwdriver : VAS6494
- Vehicle Diagnostic Tester
NOTE:
The Recirculation Door Motor -V113- can only be removed without error in the "fresh air mode stop" position and can only be installed only in this position. If the adjustment motor is stuck in a different position or can no longer be moved electrically into the "fresh air mode stop" position, then it can only be pulled off and removed with difficulty.
The position of the fresh/recirculating air door must not be changed.