Wheel Bearing Unit, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
-- Tighten nuts -arrows-.
NOTE:
Tighten the nuts -arrows- in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Install the brake caliper. Refer to OVERVIEW - FRONT BRAKES .
-- Tighten drive axle bolt onto the wheel hub. Refer to DRIVE AXLE BOLT, LOOSENING AND TIGHTENING .
-- Install the ABS speed sensor. Refer to SENSORS .
-- Install the front wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .