Overview - Drive Axle, Triple Roller Joint AAR3300I
WARNING: This page is about a different variant/trim than selected.
- Outer CV Joint
- Only replace completely
- Removing . Refer to Removing the Outer CV Joint .
- Installing : Drive onto shaft with a plastic mallet until compressed circlip rebounds.
- Checking. Refer to OUTER CV JOINT, CHECKING .
- Bolt
- 200 Nm +180°
- Replace after removing .
- Bolt, Loosening and Tightening. Refer to DRIVE AXLE, REMOVING AND INSTALLING, TRIPLE ROLLER JOINT AAR3300I
- Circlip
- Replace after removing .
- Insert in shaft groove
- Thrust Ring
- Installation position. Refer to Figure.
- Plate Spring
- Installation position. Refer to Figure.
- Clamp
- Replace after removing .
- Tensioning. Refer to Figure.
- CV Joint CV Boot
- Check for tears and scuffing
- Material: Hytrel polyelastomer
- Clamp
- Replace after removing .
- Tensioning. Refer to Figure
- Drive Axle
- Clamp
- Replace after removing .
- Tensioning. Refer to Figure
- CV Boot for Triple Roller Joint
- Check for tears and scuffing
- Clamp
- Replace after removing .
- Tensioning. Refer to Figure.
- Triple Roller Star with Rollers
The chamfer -arrow- faces the drive axle splines.
- Circlip
- Replace after removing .
- Insert in shaft groove
- Internal Multi-Point Bolt
- First tighten diagonally to 10 Nm, then tighten diagonally again to the tightening specification
- 70 Nm
- Joint