Wheel Bearing Unit, Removing And Installing: Removing

-- Loosen the wheel bolts.

-- Raise the vehicle.

-- Remove wheel.

-- Loosen dust cap from seat by tapping lightly on claw of : VW637/2  -1-.

Fig 1: Removing Dust Cap (1 Of 2)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press of dust cap.

Fig 2: Removing Dust Cap (2 Of 2)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. : VW637/2 

-- Remove the brake carrier with the brake caliper and tie them to the body with wire. Refer to OVERVIEW - REAR BRAKES .

-- Remove the brake rotor bolt and the brake rotor.

-- Remove bolt -1- using : T10162A  -2-.

Fig 3: Never Use An Impact Wrench On Bolt -1- Using Bit XZN 18 T10162 -2-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the wheel hub/wheel bearing unit -2- from the stub axle.

Fig 4: Identifying Wheel Hub/ Bearing Unit

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.