Stabilizer Bar, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

The following work steps are described for the left side of the vehicle. These work steps also apply At the same time for right side of vehicle.

-- Remove the nut -1- and pull the coupling rod -2- out of the stabilizer bar.

Fig 1: Identifying Tie Rod Bolt, Coupling Rod, Nut And Stabilizer Bar

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Do not loosen bolt -arrow- for tie rod -3-.

-- Remove the bolts -arrows- for the stabilizer bar clamp.

Fig 2: Identifying Stabilizer Bar Clip Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the stabilizer bar.