GROUND CABLE WITH Battery Monitoring Control Module -J367-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
The "replacing the battery monitoring control module" procedure must be performed each time before removing the Battery Monitoring Control Module -J367- to read the data stored in the Battery Monitoring Control Module -J367-. Refer to Vehicle Diagnostic Tester.
-- Disconnect the Battery -A-. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Release and disconnect the connector -5-.
-- Free up the ground wire -1-.
-- Remove the nut -2- and then remove the ground wire and the Battery Monitoring Control Module -J367- -1-.