Battery, Disconnecting And Connecting: Connecting
After connecting the Battery -A- and switching the ignition on, the ASR/ESP Indicator Lamp -K155- lights up continuously. The ASR/ESP Indicator Lamp -K155- goes out automatically if a straight distance is driven at 15 to 20 km/h (9 to 12 mph). This reactivates the Steering Angle Sensor -G85-.
-- Release and disconnect the connector -5- from the Battery Monitoring Control Module -J367- -3-.
-- Apply the battery ground cable clamp -4- on the negative terminal of the Battery -A- -6-.
-- Tighten the nut from the battery ground cable clamp -4- to the tightening specification.
-- Reconnect the connector -5- to the Battery Monitoring Control Module -J367- -3-.
-- Close the battery jacket or install the battery case cover and lock it into place.
-- Turn on the ignition.
-- Check the time and if necessary adjust.
-- Window, open and close all the way.
-- Then, with the windows closed, pull the power window switch until the relay audibly switches.
-- Check the window regulator convenience switch.
While comfort switching is operated, window must close without holding the power window switch.
After connecting the power supply, the ASR/ESP Indicator Lamp -K155- may only go out after the vehicle has been driven a few yards.