Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

-- Make sure the pump -1- on the controller housing -2- and the seal -3- are seated correctly -arrows-.

Fig 1: Identifying Controller Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the coolant pump bolts. Refer to Figure.

-- After installing a new coolant pump -2-, remove the cap -1- from the drive wheel.

Fig 2: Identifying Coolant Pump

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to Filling .