Fiber-Optic Cable, Disconnecting From Wiring Harness Connector: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the connector for the fiber-optic cable from the corresponding control module.

-- Release the locking mechanism in the fiber-optic cable connector -1- by pushing on it.

Fig 1: Identifying Removal Of Fiber-Optic Cable

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the secondary lock -2- using a small screwdriver.

-- Remove the fiber-optic cable.

CAUTION:

Use a protective cap from the case to protect the fiber-optic cable from dust and dirt.
Use a new housing, because the removal of the fiber-optic cable can lead to damaging the secondary lock.
Note the arrows for the "IN" and "OUT" allocation on the base module.