Round Connector Systems

WARNING: This page is about a different variant/trim than selected.

The equipped housing securing mechanisms (secondary locks) must be released or removed using the specified tool before releasing the contacts. Refer to SECONDARY LOCK .

-- Guide the corresponding connector housing release tool into the release channel on the connector housing.

Fig 1: Identifying Terminal At Wire Pushed Into Terminal Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Grip the contact at the wire and gently push it into the connector housing -arrow-.

NOTE:

By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.

-- At the same time, push the release tool in the direction of the connector housing and pull the released contact out of the connector housing.

Fig 2: Identifying Released Terminal Pulled Out From Terminal Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

After removing the contact, release tool can be pulled out of the connector housing again.