Midtronics Battery Tester: MCR340VKT TROUBLESHOOTING
WARNING: This page is about a different variant/trim than selected.
Sometimes the display shows the malfunction or the messages based on the condition.
The following is a list of the most frequent displayed messages together with suggested solutions.
Refer to the : MCR340VKT Operating Instructions for any messages not listed.
| Display Message | Steps |
|---|---|
| No display | -- Make sure the : MCR340VKT test terminals are attached securely to the battery terminals. -- Make sure the terminals are not corroded and are tightened to the correct tightening specification. Refer to BATTERY, REMOVING AND INSTALLING . -- Charge the Battery -A-. Refer to BATTERY, CHARGING . |
| System noises | -- Turn off all electrical equipment. -- Wait until all electrical equipment monitored by the Vehicle Electrical System Control Module -J519- is switched off. -- Remove the ignition key. -- Disconnect any questionable, non-series production electrical equipment from the vehicle electrical system. |
-- Wait a few minutes and then check again. Refer to BATTERY TEST, PERFORMING USING Midtronics Battery Tester .
NOTE:
If the test was performed at the battery jump start terminal and the message still does not go away, then perform the test directly on the Battery -A-.