Battery Tester Charger Kit: GRX3000VAS TROUBLESHOOTING
WARNING: This page is about a different variant/trim than selected.
Sometimes the display shows the malfunction or the messages based on the condition.
The following is a list of the most frequent displayed messages together with suggested solutions.
NOTE:
For any messages not listed, refer to the : GRX3000VAS Operating Instructions.
| Display Message | Steps |
|---|---|
| Connection, Checking | -- Make sure the : GRX3000VAS charging clamps are attached securely to the battery terminals. -- Make sure the battery terminal is tightened to the tightening specification and is not corroded. |
| Terminals connected? | : GRX3000VAS safety function. -- Connect the charging clamps to the Battery -A- before starting the charging process. |
| System noises | -- Turn off all electrical equipment. -- Wait until all electrical equipment, which are monitored by the Vehicle Electrical System Control Module -J519-, are switched off. -- Remove the ignition key. -- Disconnect any questionable, non-series production electrical equipment from the vehicle electrical system. |
-- Wait a few minutes and repeat the charging process. Refer to BATTERY, CHARGING WITH