BATTERY, CHARGING WITH Battery Charger: VAS5095A
Special tools and workshop equipment required
- Battery Charger: VAS5095A
Risk of injury! Pay attention to all warnings and safety precautions. Refer to WARNINGS AND SAFETY PRECAUTIONS .
While charging, always set the battery type to 2.4 V/C (Volts/Battery cell)! This applies to all Batteries -A-.
The Battery -A- temperature must be at least 10 °C (50 °F).
Do not check or charge a Battery -A- when the visual indicator has >>no color or is bright yellow<<. Do not give a jump start.
There is a risk of explosion during testing, charging or jump starting.
These Batteries -A- must be replaced.
Procedure
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Check the battery type setting on the battery type switch. Refer to Battery Charger . The battery type switch must be set to 2.4V/C (Volts/Battery Cell).
-- Connect the red charge terminal (+) to the positive terminal of the Battery -A-.
On vehicles with a Start/Stop function and an installed Battery Monitoring Control Module -J367-, the black charge terminal (-) must be connected to the body ground. The Start/Stop system will malfunction when it is connected to the Battery -A- negative terminal.
-- Connect the black charge terminal (-) to the negative terminal of the Battery -A- /negative connector.
-- Switch on the : VAS5095A . Refer to Battery Charger .
Charge current displays Figure -2 and 3- light up yellow. The Battery -A- is partially charged (approximately 90 %) when only the yellow LED -3- is on.
If the green LED Figure -4- is also on, then the : VAS5095A has switched to maintenance charging. The Battery -A- is charged.
-- Switch off the : VAS5095A . Refer to Battery Charger .
-- Remove the charging clamps from the battery terminal clamps.