LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Wheels, Tires, Wheel Alignment (Suspension, Wheels, Steering) (Convertible)) >> 44 Wheels, Tires, Wheel Alignment >> Wheels And Tires >> Wheel, Changing >> Wheel Changing And Wheel Installation

Wheel Changing And Wheel Installation

WARNING: This page is about a different variant/trim than selected.

-- Coat the wheel centering seat with protective material. Refer to WHEEL CHANGING, PROTECTING WHEEL CENTERING SEAT AGAINST CORROSION .

Fig 1: Identifying Incorrect Tightening Method
GWWN44-10331Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. When mounting a wheel, tighten all wheel bolts uniformly by hand.
  2. Tighten the wheel bolts diagonally to approximately 30 Nm.
  3. Lower the vehicles onto the floor. Tighten all the wheel bolts diagonally to the tightening specification using a torque wrench. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
WARNING:

Do not use an impact wrench to install the wheel bolts.

scientia non olet · About LEMON Manuals