Rear Axle Camber, Adjusting: Notes

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required

-- Loosen nut -A- of threaded connection of upper transverse link at subframe.

Fig 1: Identifying Upper Transverse Link Threaded Fastener Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Adjust camber by turning hex of eccentric bolt -arrow-.

NOTE:

The maximum adjustment range is 90° to left or right of center position.

-- Tighten the nut -A-.

Fig 2: Identifying Upper Transverse Link Threaded Fastener Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the :T10179 for this.

Fig 3: Identifying Nut & T10179

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tighten the Nut to 80 Nm using the :T10179 .

-- Check the camber value again after tightening the nut -A-.