Measurement Preparations
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Wheel Alignment Computer:VAG1813F or VW/Audi approved wheel alignment devices
- Brake Pedal Actuator:VAG1869/2 .
- Insert Tool - 18mm:T10179
- Shock Absorber Set:T10001
The Lateral Run-Out of the Wheel Must Be Balanced (Compensated For). Otherwise, the Measurement Result Will Be False.
A Correct Toe-In Adjustment Will Not Be Possible without Performing Lateral Run-Out Compensation!
Follow the operating instructions provided by the manufacturer of the alignment equipment.
-- Carry out wheel run-out compensation.
-- Install the :VAG1869/2 .
-- Actuate the brake pedal using brake pedal actuator.