Axle Alignment Procedure
WARNING: This page is about a different variant/trim than selected.
The Following Sequence of Procedure Steps Must Be Observed.
-- Note the information in the alignment equipment.
Measuring Procedure
| Start | → | Perform wheel run-out compensation. | → | Bounce vehicle | ||||||
| ↓ | ||||||||||
| Turn the steering wheel into the straight ahead position and secure it (1) | ← | Measure vehicle height | ← | Install the :VAG1869/2 . | ||||||
| ↓ | ||||||||||
| Check camber at front axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjust. Refer to FRONT AXLE CAMBER, ADJUSTING . | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check rear axle camber | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjust. Refer to REAR AXLE CAMBER, ADJUSTING . | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check toe at rear axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjust. Refer to REAR AXLE TOE, ADJUSTING . | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check caster at front axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Check the axle components and assembly | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check toe at front axle | → | Is actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| End | ← | Yes | Adjust. Refer to FRONT AXLE TOE, ADJUSTING . | |||||||
| ↑ | ↓ | |||||||||
| ↑ | ← | ← | ← | ← | ← | |||||
|
||||||||||