LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Wheels, Tires And Wheel Alignment (Wheel And Tire Guide General Information) (Convertible)) >> 44 Wheels, Tires And Wheel Alignment >> Wheel, Changing >> Wheel, Mounting

Wheel, Mounting

WARNING: This page is about a different variant/trim than selected.

-- Coat the wheel centering seat with protective material. Refer to WHEEL CENTERING SEAT, PROTECTING AGAINST CORROSION .

Fig 1: Identifying Incorrect Tightening Method
GWWN44-10331Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. When mounting a wheel, tighten all wheel bolts evenly by hand.
  2. Tighten the wheel bolts diagonally to approximately 30 Nm.
  3. Lower the vehicles onto the floor. Using the torque wrench, tighten all wheel bolts to the tightening specification in a diagonal sequence. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
CAUTION:

Wheel bolts installed with an impact wrench can become loose.

- Install all wheel bolts evenly by hand.

- Tighten the wheel bolts diagonally to approximately 30 Nm.

- Using the torque wrench, tighten the wheel bolts to the tightening specification in a diagonal sequence.

scientia non olet · About LEMON Manuals