Rim Radial And Lateral Run-Out, Checking: Notes

WARNING: This page is about a different variant/trim than selected.

-- Mount the rim on the Balancing Machine.

-- Use the Wheel Centering System Adapter: VAS5271 .

-- Preload the Tire Pressure Gauge approximately 2 mm.

-- Turn the rim slowly.

-- Note the smallest and the largest dial readings.

Fig 1: Identifying Areas To Check Wheel For Radial Run-Out & Lateral Run-Out

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

S - Lateral Run-Out

H - Radial Run-Out

-- Compare the determined value with the specifications in the table. Refer to Specified Values for Radial and Lateral Run-Out on the Rim .

NOTE:

Peak values on the Tire Dial Gauge due to small irregularities may be disregarded.