LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Wheels, Tires And Wheel Alignment (Wheel And Tire Guide General Information) (Convertible)) >> 44 Wheels, Tires And Wheel Alignment >> Disc Wheel (Rim), Information >> Valve, Removing And Installing >> Valve, Removing And Installing, Metal Valve >> Installing

Valve, Removing And Installing, Metal Valve: Installing

WARNING: This page is about a different variant/trim than selected.
NOTE:

Only apply the specified torque to tighten the nut for the metal valve.

Tightening more is not permitted because it damages the seal.

-- Tighten the nut -1- of the metal valve.

Fig 1: Identifying Metal Valve
GWWN44-10443Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.

-- Install the Tire Pressure Monitoring Sensor --. Refer to TIRE PRESSURE MONITORING SENSOR, REMOVING AND INSTALLING, WITHOUT VALVE, VERSION 1, SERVICE VERSION .

scientia non olet · About LEMON Manuals