Central Locking Overview, Convertible
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Alarm Horn -H12-
- Installed location: in the plenum chamber
- Removing and installing, refer to REMOVAL AND INSTALLATION .
- Connector Station
- Location: Left A-pillar in the vehicle interior
- Remove the A-pillar lower trim to disconnect the connector, refer to Removal and Installation
- Front Passenger Door Control Module -J387-
- Integrated inside the Front Passenger Window Regulator Motor -V148-
- Removing and Installing, refer to WINDOW REGULATOR MOTOR .
- Front Passenger Door Central Locking System Motor -V57-
- Integerated in the door lock on the front passenger side
- Removing and Installing, refer to DOOR LOCK .
- Right Rear Door Control Module -J389-
- Integrated inside the Right Rear Window Regulator Motor -V27-
- Removing and Installing, refer to SIDE WINDOW REGULATOR MOTOR, CONVERTIBLE .
- Fuel Filler Door Unlock Motor -V155-
- Removing and Installing, refer to ACTUATOR .
- Rear Lid Opening Motor -V254-
- Integrated inside the rear lid lock
- Removing and Installing, refer to REAR LID LOCK, SEDAN .
- Release Button In Rear Lid Handle -E234-
- Integrated in the mechanism
- Removing and Installing, refer to REAR LID ACTUATOR .
- Left Rear Door Control Module -J388-
- Integrated inside the Left Rear Window Regulator Motor -V26-
- Removing and Installing, refer to SIDE WINDOW REGULATOR MOTOR, CONVERTIBLE .
- Driver Door Central Locking System Motor -V56-
- Integerated in the door lock on the driver side
- Removing and Installing, refer to DOOR LOCK .
- Driver Door Control Module -J386-
- Integrated inside the Driver Window Regulator Motor -V147-
- Removing and Installing, refer to WINDOW REGULATOR MOTOR .
- Power Window Control Head in Driver Door -E512-
- Installed location: inside the driver door trim panel
- Removing and Installing, refer to REMOVAL AND INSTALLATION
- Connector Station
- Location: Left A-pillar in the vehicle interior
- Remove the A-pillar lower trim to disconnect the connector, refer to REMOVAL AND INSTALLATION
- Vehicle Electrical System Control Module -J519-
- Installed location: under the instrument panel on the driver side
- Removing and Installing, refer to REMOVAL AND INSTALLATION .
- Engine Hood Contact Switch -F266-
- Installed location: on the latch
- Removing and Installing, refer to HOOD LATCH .