Turbocharger Vacuum Diaphragm, Replacing: Notes
WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Socket 10 mm T10422 A
- Ring Spanner 10 x 12 T10423
- Hand Vacuum Pump VAS 6213
- Engine Bung Set VAS 6122
NOTE:
Replacing the vacuum diaphragm and Charge Pressure Actuator Position Sensor -G581-
CAUTION:
The specified special tools, in particular the Socket 10 mm T10422 A, are designed exclusively for use according to the following work procedure and may not be used for other screw connections. Higher torques can cause deformation.
NOTE:
A replacement part kit is available for the replacement of the pressure cell with the Charge Pressure Actuator Position Sensor -G581-. Refer to the Parts Catalog.