LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (1.8L & 2.0L Turbocharger, Supercharger - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Convertible)) >> 21 Turbocharger, Supercharger >> Removal And Installation >> Charge Air Pressure Sensor -G31- >> Removing

Charge Air Pressure Sensor -G31-: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove air filter housing, refer to AIR FILTER HOUSING .

-- Disconnect the connector -2-.

Fig 1: Identifying Charge Air Pressure Sensor
GWWM21-10014Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and pull the Charge Air Pressure Sensor -G31- -1- out of the air guide pipe and remove it upward.

NOTE: The bolts are each accessible in front of and behind the coolant hose from above.
scientia non olet · About LEMON Manuals