LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Seat Upholstery, Covers (Convertible)) >> 74 Seat Upholstery, Covers >> Removal And Installation >> Front Seat Covers And Cushions >> Backrest Cover And Cushion >> Removing

Backrest Cover And Cushion: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Attach the Engine/Transmission Holder - Seat Repair Fixture VAS 6136 onto the Engine And Transmission Holder VAS 6095.

-- Remove the front seat. Refer to FRONT SEAT .

-- Secure the seat on the Engine/Transmission Holder - Seat Repair Fixture VAS 6136.

-- Remove the back rest adjustment wheel. Refer to BACKREST ADJUSTMENT WHEEL .

-- Remove the seat height adjustment handle. Refer to SEAT HEIGHT ADJUSTMENT HANDLE .

-- Remove the trim on the door sill side, refer to DOOR SILL SIDE SEAT TRIM .

-- Remove the trim on the tunnel side, refer to TUNNEL-SIDE SEAT TRIM .

Fig 1: Removing Back rest Cover
GWWM74-10004Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the back rest. Refer to FRONT BACKREST .

-- Remove the headrest. Refer to HEADREST .

Vehicles With Manual Lumbar Support Adjustment 

-- Remove the lumbar support adjusting lever -2- using the Door Trim Pliers 3392.

Continuation For All Vehicles 

-- Open the retaining channel -5- in direction of -arrow-.

Cover With Map Pocket 

-- Remove the clip -3- from both sides of the back of the back rest frame -4-.

Fig 2: Removing Back rest Cover
GWWM74-10005Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Fold up the back rest cover -1- slightly upward.

-- Disengage tension wire -5- on the left and right sides of the back rest frame.

-- Remove the upholstery clips of the cover -1- alternately from the cushion -4- and unclip the clips for the cover -1- from the mounts in the cushion -2- using a small screwdriver.

-- Fold the cover -1- up further and remove it from the cushion -3-.

-- Push the cushion -3- over both headrest guides and remove it from the back rest frame.

Vehicles With Seat Heating 

NOTE:

If, on a vehicle with seat heating, the cushion -1- or the back rest heating element -2- is faulty, always replace both components.

Fig 3: Identifying Seat Heating Element And Cushion
GWWM74-10025Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.