High-Mounted Brake Lamp Bulb -M25-
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
If one of the LEDs in the High-Mounted Brake Lamp Bulb -M25- is faulty:
- The individual LEDs in the High-Mounted Brake Lamp Bulb -M25- are in groups of four and supply electricity as a group.
- The High-Mounted Brake Lamp Bulb -M25- is designed in such a way that it still meets legal requirements when one LED group fails.
- If another LED group fails, these legal requirements are no longer met.
- When one LED group fails, the intact LEDs are given a higher load, by which failure of other LED groups can be assumed in the near future.
- Replace the High-Mounted Brake Lamp Bulb -M25- if more than four separate LEDs have burned out in the High-Mounted Brake Lamp Bulb -M25-.
Removal
-- Turn off the ignition and all electrical consumers and remove the ignition key.
-- Remove the rear lid lower trim panel, refer to REMOVAL AND INSTALLATION .
-- Press the tabs -arrows- with the screwdriver and remove the High-Mounted Brake Lamp Bulb -M25- -1- outward.
-- Disengage the connector -2- and disconnect.
Installation
Install in reverse order of removal. Note the following:
-- Check the functionality of the High-Mounted Brake Lamp Bulb -M25-.