Calibration, Performing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The following should not occur during the calibration procedure:

Vehicle doors must not be opened or closed.
People should not sit in the vehicle.
People must not go between the vehicle and the Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance.

Procedure

-- Perform the preparation work, refer to PREPARING FOR CALIBRATION .

-- Turn on the Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance on the voltage switch -3-.

Fig 1: Identifying Assistance Calibration Device VAS 6350/4 Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The green LED -1- must light up.

NOTE:

The red LED -2- illuminates: check the Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance.

-- Connect Vehicle Diagnostic Tester.

-- Select calibration in the "Guided Fault Finding" mode.

-- Follow the instructions in the display using the Vehicle Diagnostic Tester.

During the course of the program, a request is made to switch the Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance from the left to the right side of the Calibration Tool VAS 6350.

Fig 2: Identifying Calibration Tool - Lane Change Calibration Tool VAS 6350/4

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Switch of the Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance and remove the Calibration Tool VAS 6350.

When installed correctly, vehicle electrical system voltage line must be connected at bottom left of Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance (as seen in direction of travel).
Dimension -a- = 543 mm (measured from upper edge of Calibration Device VAS 6350 to the floor).
Right setting = 865 mm (read on measurement scale -1-).

-- Turn on the Calibration Tool - Lane Change Calibration Tool VAS 6350/4 for the lane change assistance on the voltage switch -3-.

Fig 3: Identifying Assistance Calibration Device VAS 6350/4 Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The green LED -1- must light up.

-- Follow the instructions in the display using the Vehicle Diagnostic Tester.