LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Passenger Protection, Airbags & Seat Belts (Convertible)) >> 69 Passenger Protection, Airbags, Seat Belts >> Description And Operation >> Seat Occupied Recognition Overview >> Passenger Occupant Detection System Overview, Sport >> Disconnecting Connector from Passenger Occupant Detection System Control Module -J706-

Disconnecting Connector from Passenger Occupant Detection System Control Module -J706-

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting The Connectors From Passenger Occupant Detection System Control Module
GWWN69-10555Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Disconnecting Voltage Supply Connector

-- Press the release -1-. Disconnect the connector -4- from the Passenger Occupant Detection System Control Module -J706- -5-.

Disconnecting Passenger Occupant Detection System Pressure Sensor -G452- Connector

-- Press the release -3-. Disconnect the connector -6- from the Passenger Occupant Detection System Control Module -J706- -5-.

NOTE:

The connectors -4 and 6- on the Passenger Occupant Detection System Control Module -J706- -5- have seals. The seal protect against moisture.

Avoid removing and then installing the seal so that the seal remains tight.

Route the wiring harnesses as before after replacing any components one they have been connected to the control module.

scientia non olet · About LEMON Manuals